|
Timberline Clamps
These innovative products allow both structural
and wildland fire agencies to clamp various types and sizes
of fire hose safely, effectively, and efficiently with virtually
no chance of pinching or damaging the hose. Traditional hose
clamp designs are specific to certain types of hose and many
allow "walking" of the hose, which can lead to a
pinch and possible burst of the hose line.
Hose Clamps
A burst hose is a safety concern for spacerfirefighters on the
line who are depending on that water supply as not only their
weapon against the fire, but for personal protection as well.
Every Timberline Tool is manufactured from high quality aircraft
grade aluminum using advanced design and quality control programs.
The tools are lightweight, durable, and designed for serious
professionals who are concerned about performance and safety.
Full
Information & Specs | Request
a Quote
Around-the-Pump
A simple and directly manageable system that enables the injection
of firefighting foams at the suction side of the pump where
positive head pressure exists due to pump location and/or tank
configuration. The APM10 allows for injection and mixing at
low flows, includes internal check valve and shutoff, has adjustable
setting for flow control that can be adjusted manually and is
easily removed for maintenance and other uses.
Full
Information & Specs | Request
a Quote
This multi-expansion aspirating foam nozzle is constructed of
pressure injected polymer resins that make it economical, lightweight
but extremely rugged. The Madd Dog is capable of low to medium
foam expansion rates depending on the supporting equipment that
is used.
The Madd Dog can be used with a variety of fire nozzles or it
can be purchased with a 1.5" lexan nozzle (as shown in
the image at left). Request
a Quote
GF100 Meter
This small, lightweight and portable metering device operates
on any high pressure or volume pump and has a selection of six
orifice settings that are controlled manually. Each orifice
setting (A-F) allows for a certain percentage injection rate
depending on pump performance. Select A-C for light foam or
wet water, and D-F for thicker foam at the nozzle. The GF100
also includes an "OFF" setting to shut down the supply
of foam concentrate. There is a built-in check valve that prevents
water backflow into the additive container when the pump is
shut down. Request
a Quote |
